Program EFM8 devices using an Arduino Mega.
Thanks to jaromir-sukuba and racerxdl for working on firmware to implement C2 protocol via arduino GPIO. This work largely pulls from them.
Currently, it is for Arduino Mega and maps C2D and C2CK to digital pins 2 and 3, respectively.
C2 is a 2-pin protocol. Any arduino should work to implement the protocol via GPIO. Just need to make sure that the correct pins are mapped for your Arduino.
Check the firmware file and change the pins to map to your device if needed.
To use it for Arduino Uno you can just swap from E to D. Just replace all PORTE
, DDRE
and PINE
with PORTD
, DDRD
and PIND
. You can read about Port Registers here: https://www.arduino.cc/en/Reference/PortManipulation
Program the firmware to the arduino and connect C2D, C2CK, and GND to your target device.
It is set up in a client/server model to be able to easily support programming multiple targets at the same time.
pip install -r requirements.txt
First you must run the server that will handle communication to the arduino.
python prog_server.py <serial-port> [<serial-port2> ...]
Supply a list of serial ports (you can use more than one Arduino at a time) to handle programming. E.g /dev/USB1 or COM1 or /dev/cu.usbmodem*.
Then you can finally program something using the client script.
python prog_client.py <serial-port> <firmware.hex>
This will connect to the server and tell it to download specified firmware via specified arduino.