corygrant DingoPDM_FW issues

corygrant / DingoPDM_FW

MIT License

1 stars 4 forks source link

issues

Newest

Newest Most commented Recently updated Oldest Least commented Least recently updated

Config check bytes to CRC

#28 corygrant opened 1 month ago
0
Warning/error messages are sent too fast

#27 corygrant closed 4 weeks ago
0
Reset time and inrush time scale

#25 corygrant closed 1 month ago
0
Digital input on at power on doesn't register as on

#24 corygrant closed 2 months ago
1
Add device state back to CAN output

#23 corygrant closed 2 months ago
0
Move Flasher to variable map

#22 corygrant closed 1 month ago
0
Store name strings on device

#21 corygrant opened 2 months ago
1
Configurable CAN bit rate

#20 corygrant closed 1 month ago
1
Firmware update without changing boot switch

#19 corygrant opened 2 months ago
0
Finish overtemp and error handling

#18 corygrant closed 2 months ago
2
Create a turn signal/hazard module

#17 corygrant closed 1 month ago
2
Add PWM to outputs

#16 corygrant opened 2 months ago
0
Implement low power mode

#15 corygrant closed 2 months ago
5
Investigate using CANOpen instead of custom comms

#14 corygrant opened 3 months ago
0
Add a Count mode to inputs

#13 corygrant opened 3 months ago
0
Add keypad configuration

#12 corygrant opened 4 months ago
0
Add keypad support

#11 corygrant opened 4 months ago
1
Reset time not working properly

#10 corygrant closed 4 months ago
0
Calibrate output current and battery voltage

#9 corygrant closed 4 months ago
0
Upload/download sometimes doesn't see a lot of responses

#8 corygrant closed 5 months ago
1
IWDG needs to be set up

#7 corygrant opened 6 months ago
0
No error state handling

#6 corygrant closed 5 months ago
2
Status and Error LEDs need programmed

#5 corygrant closed 2 months ago
1
Cannot control pullup/pulldown on digital inputs

#4 corygrant closed 6 months ago
0
Wiper park level not writing to memory config

#3 corygrant closed 2 months ago
1
Enable outputs doesn't have any effect

#2 corygrant closed 2 months ago
1
Shut off outputs when board temp is too high

#1 corygrant closed 5 months ago
1