Open raftheunis87 opened 3 months ago
Hello @raftheunis87 , I am not sure how this line reflects the configuration:
network_device: 192.168.30.44:3335
but for port 3335 you should use enhanced protocol so in config it shold be: enh:192.168.30.44:3335
Can you confirm this is the case?
Hey @danielkucera ,
That enh is configured under the 'mode' part in the config.
Okay then. In the ebusd log I don't see many problems but your devices complaining are not okay. Can you check if powering the adapter from USB resolves the problems with your controller and pump?
Hello,
I've recently purchased your EBUS to WiFi Adapter Module V6.1 module.
I have updated the module to the latest firmare (firmware-HW_v5.x-62ebb2.bin).
I have a Vaillant FlexoTherm VFW 87/4 with a Vaillant VRC 700 thermostat. I have connected the module to the ebus wires behind the VRC 700.
I was able to connect it to my local network, and I have configured the ebusd add-on in Home Assistant as follows:
The configs on the configpath are from https://github.com/jonesPD/ebusd-configuration
I get the following errors in the logs in the add-on:
I also get an error on both the VRC 700 and on my heat pump.
Any idea what I can do to resolve this?
Thanks in advance.