search

fieldOfView / Cura-ZOffsetPlugin

A Cura plugin that adds a Z Offset setting
GNU Affero General Public License v3.0
47 stars 10 forks source link

Offset Issue with Cura 4.7.1 #17

Closed hparHelios closed 3 years ago

hparHelios commented 4 years ago

Using a Z offset sets the offset incorrectly. I used a 0.1mm offset and it printed at a couple of centimeters which caused the print to fail.

muenznej commented 3 years ago

i am using it for 4.7 and its option is grey ( i think inactive ), dont know why

fieldOfView commented 3 years ago

@hparHelios, I am sorry I totally forgot about this issue. What printer do you use? Have you tried using the "Extensive Z Offset Processing" option?

@muenznej, this sounds like a completely different problem than what @hparHelios is describing. Please could you open a new issue instead of attaching your problem to this one?

hparHelios commented 3 years ago

@hparHelios, I am sorry I totally forgot about this issue. What printer do you use? Have you tried using the "Extensive Z Offset Processing" option?

@muenznej, this sounds like a completely different problem than what @hparHelios is describing. Please could you open a new issue instead of attaching your problem to this one?

fieldOfView,

Apologies for the delay as I've been out of the office this past week. I am using the Ultimaker S5 printer.

fieldOfView commented 3 years ago

I can't reproduce this. If it is still happening, can you please post a link to a gcode or ufp file so I can inspect the gcode that is created? What firmware version do you have on your S5?

fieldOfView commented 3 years ago

I can't fix this without further info. If you can post a link to a gcode or ufp file so I can inspect the gcode that is created I will reopen the issue.