homebridge-xiaomi-purifier-3

Features

• Switch on / off.

• Switch auto / manual mode.

• Change fan rotation speed.

• Switch child lock on / off.

• Switch LED light on / off.

• Switch buzzer sound on / off.

• Display temperature.

• Display humidity.

• Display air quality.

• Display filter state.

Installation

1. Install required packages.

    npm install -g homebridge-xiaomi-purifier-3

2. Make sure your Homebridge server is same network with your device, then run following command to discover the token.

    miio discover --sync

3. You may need to wait few minutes until you get the response similar to below:

    Device ID: 49466088
    Model info: Unknown
    Address: 192.168.1.8
    Token: 6f7a65786550386c700a6b526666744d via auto-token
    Support: Unknown

4. Record down the Address and Token values as we need it in our configuration file later.

5. If you are getting ?????????????? for your token value, please reset your device and connect your Homebridge server directly to the access point advertised by the device.

6. Then run the command again.

    miio discover --sync

7. Add following accessory to the config.json .

        "accessories": [
            {
                "accessory": "MiAirPurifier3",
                "name": "Bed Room Air Purifier",
                "ip": "192.168.1.x",
                "token": "xxxxxxxxxxxxxxxxxxx",
                "did": "xxxxxxxxx",      
                "enableLED": true (optional),
                "enableLEDName": "Some custom LED name" (optional),
                "enableBuzzer": true (optional),
                "enableBuzzerName": "Some custom buzzer name" (optional),               
                "showTemperature": true,
                "showTemperatureName": "Some custom Temperature name" (optional),
                "showHumidity": true (optional),
                "showHumidityName": "Some custom Humidity name" (optional),
                "showAirQuality": true (optional),
                "showAirQualityName": "Some custom Air Quality name" (optional),
                "pm25_breakpoints": [5, 12, 35, 55] (optional),
                "polling_interval": 60000 (optional)
            }
        ]

**Notes:** Set value for `enableLED` , `enableBuzzer` , `showTemperature` , `showHumidity` , `showAirQuality`  to **true** or **false** to show or hide these sensors in Home app.

8. Restart Homebridge, and your device will be added to Home app.

License

MIT License