trying to get this to work, but the temparature range always jumps back to just one figure (say only 20 degrees) instead of 20-24 degress, no matter how often I set the range new.
Is this because Melcloud is still not support this or I am doing something wrong here?
Also as a side topic: I dont get the difference in control modes: Thermostat and Heater/Cool, is the only difference the Fan modes and the Swing?
I am running a homekit automation where the room temparatue is taken from my Meross Thermostat and if the temarature is over 24 degrees I would like to cool down until it reaches 22 degrees. The automation triggers the cooling mode, but it does not stop when 22 degrees are reached. Any tips for that, too? Thanks!
Hi folks,
trying to get this to work, but the temparature range always jumps back to just one figure (say only 20 degrees) instead of 20-24 degress, no matter how often I set the range new.
Is this because Melcloud is still not support this or I am doing something wrong here?
Also as a side topic: I dont get the difference in control modes: Thermostat and Heater/Cool, is the only difference the Fan modes and the Swing?
I am running a homekit automation where the room temparatue is taken from my Meross Thermostat and if the temarature is over 24 degrees I would like to cool down until it reaches 22 degrees. The automation triggers the cooling mode, but it does not stop when 22 degrees are reached. Any tips for that, too? Thanks!