OctoPrint-TPLinkSmarBulb

Work inspired by OctoPrint-PSUControl and TP-Link WiFi SmartPlug Client, this plugin controls a TP-Link SmartBulb via OctoPrint's nav bar and GCODE commands.

Screenshots

Setup

Install via the bundled Plugin Manager or manually using this URL:

https://github.com/jneilliii/OctoPrint-TPLinkSmarBulb/archive/master.zip

Configuration

Once installed go into settings and enter the ip address for your TP-Link SmartBulb. Adjust additional settings as needed.

Settings Explained

• IP
  • IP or hostname of bulb to control.
• Label
  • Label to use for title attribute on hover over button in navbar.
• Icon Class
  • Class name from fontawesome to use for icon on button.
• Warning Prompt
  • Always warn when checked.
• Warn While Printing
  • Will only warn when printer is printing.
• GCODE Trigger
  • When checked this will enable the processing of M80 and M81 commands from gcode to power on/off bulb. Syntax for gcode command is M80/M81 followed by hostname/ip. For example if your bulb is 192.168.1.2 your gcode command would be M80 192.168.1.2
  • When enabled M150 GCODE commands will also get translated and submitted to the bulb to change the color of the bulb. Use the format M150 R U B P W I. For example M150 I192.168.1.2 R255 G128 B128 P128 will turn the bulb with ip 192.168.1.2 to an orangish color at 50% brightness.
  • Auto Connect
  • Automatically connect to printer after bulb is powered on.
  • Will wait for number of seconds configured in Auto Connect Delay setting prior to attempting connection to printer.
• Auto Disconnect
  • Automatically disconnect printer prior to powering off the bulb.
  • Will wait for number of seconds configured in Auto Disconnect Delay prior to powering off the bulb.
• Run System Command After On
  • When checked will run system command configured in System Command On setting after a delay in seconds configured in System Command On Delay.
• Run System Command Before Off
  • When checked will run system command configured in System Command Off setting after a delay in seconds configured in System Command Off Delay.

Get Help

If you experience issues with this plugin or need assistance please use the issue tracker by clicking issues above.

Additional Plugins

Check out my other plugins here

Sponsors

• Andreas Lindermayr
• @TheTuxKeeper
• @tideline3d
• SimplyPrint
• Andrew Beeman
• Calanish
• Lachlan Bell
• Jonny Bergdahl

  Support My Efforts

  I, jneilliii, programmed this plugin for fun and do my best effort to support those that have issues with it, please return the favor and leave me a tip or become a Patron if you find this plugin helpful and want me to continue future development.

No paypal.me? Send funds via PayPal to jneilliii@gmail.com