REMKO.de Heat Pump - Home Assistant Integration

If your REMKO Heat Pump has a SmartControl interface and it has connected to your lan network. You can send POST commands to control settings.

To have this dashboard also check this template: https://github.com/jovana/remko-heat-pump/wiki/REMKO-Dashboard-template

REMKO WKF-Compact

This manual has been tested on a WKF120 device, running software version 4.23. https://www.remko.de/en/products/new-energies/smart-heat-pumps/wkf-compact-series/

Example commands (using curl)

In the below examples you need to replace first. This IP address you can found in the settings section of your device. Read below how to find your IP Address.

Switch OFF the Domestic Hot Water Heating

curl --request POST \
  --url 'http://<YOUR_IP_ADDRESS>/cgi-bin/webapi.cgi' \
  --header 'Content-Type: application/json' \
  --data '{"SMT_ID": "0000000000000000","query_list":[1079],"values": {"1079":"03"}}'

Switch standby the Heating / Cooling mode

curl --request POST \
  --url 'http://<YOUR_IP_ADDRESS>/cgi-bin/webapi.cgi' \
  --header 'Content-Type: application/json' \
  --data '{"SMT_ID": "0000000000000000","query_list":[1088],"values": {"1088":"03"}}'

REMKO Command table (version 4.23)

The table containing command codes can be found here: https://github.com/jovana/remko-heat-pump/wiki/REMKO-Command-table-(version-4.23)

REMKO Getting values table (version 4.23)

The table containing commands to retrive values can be found here: https://github.com/jovana/remko-heat-pump/wiki/REMKO-Getting-values-table-(version-4.23)

Getting your IP Address

Information --> Basic Information --> Status --> Ip Address

Expert password

To enter the Expert settings, you need a password. The default password is: 0321

Installing Remko Heatpump Sensors into Home Assistant

1. Copy the folder remko_heatpump to the config/custom_components folder of your Home Assistant installation.

2. Add to your configuration.yaml the below line:

   remko_heatpump:
   # Make sure you have a line break if this is the last line in your configuration.yaml.

3. Add the IP address or hostname from the interface into const.py. Example:

   BASE_API_URL = "http://192.168.1.68"