I'm trying to wire the micro switch to the Ender3 S1 Pro and I'm not having any luck. I have been trying the "Z Limit Interface" but it's 3 prongs, so I've tried all the combos but none of them work.
How am I supposed to wire the Klack to the S1 Pro motherboard?
You should absolutely be able to use the z limit pins. Only use IO and GND and not 5v. Identify the pin mapping of the IO pin and add that to klipper config under probe_pin
I'm trying to wire the micro switch to the Ender3 S1 Pro and I'm not having any luck. I have been trying the "Z Limit Interface" but it's 3 prongs, so I've tried all the combos but none of them work. How am I supposed to wire the Klack to the S1 Pro motherboard?