The heating (flame) is flashing green instead of red if I turn on heating

[nobirdnobird]

1st of all thank you for implementing this module in HA !

I have a "Intex Pure SPA Bubble GreyWood XXL Deluxe 28442" an I have the issue that if I turn on heating via HA the heating symbol (flame) is switching to flashing green and it seems a timer is activated, because there is shown a three hour timer and the flame symbol in the controller device.

If I press the flame button manually there is a red flame shown and the heating is starting.

[mathieu-mp]

Hi @nobirdnobird ,

When the heating is enabled via the integration, it uses the timer settings defined on the physical remote control. Removing the Heater Duration Timer from the remote control should make the home assistant integration set the spa expected temperature without timer.

To remove the Heater Duration Timer, set it to 000 hours according to the Operation Manual (Wifi wireless Spa Manual), section "Spa Control Panel".

Let us know if this solves your issue.

[mathieu-mp]

Hi @nobirdnobird , Did my previous answer solve your issue ?

[nobirdnobird]

Hi @mathieu-mp, sorry for the delay answering.

I found out, that the green flame stand for target temperature reached and it is "on" but not heating anymore.

So every thing is fine.

BR

[nobirdnobird]

To add a request for a feature:

If the target temperature is reached, the heating symbol in HA should change in the same way from red to green as it is shown on the control unit. BR

[mathieu-mp]

Hi @nobirdnobird

Thank you for your response. Your feature request is legitimate, but can't be done in the current state of our knowledge about the status message returned by the spa (cf. #46)