Elevator

A small and simple elevator script.

scm add elevator

The UI for the monitor is not yet finished.

Requires Create and CC: Tweaked.

Setup

Server Setup

[1] Rope Pulley which will move the platform up and down. (Don't forget the glue connecting platform and monitor!)
[2] Gearshift to handle the direction the platform is moving. If it is on, the platform will move down, if it's off, the platform will move up.
[3] Sequenced Gearshift handles the distance between floors. In this case, 4m are 4 blocks between each floor. To move the elevator, the Sequenced Gearshift has to be powered by a single redstone impulse.
[4] (Creative Motor) This should be replaced with your own source of energy.
[5] Computer that acts as a server and thus needs a modem. Note the redstone connections, those should always be on the correct sides. The computer is facing towards the bottom of the image. ([3] connects to the back of the server and [2] connects to the left side of the server.)

For testing purposes I would suggest to put a lever on the [2] Gearshift and a button on the [3] Sequenced Gearshift.

Floor Setup

[1] Computer that should be placed on each floor, next to where the monitors will be. Each computer requires a modem. Every Computer should have a button on it to call the elevator.
[2] Two monitors which are glued to the moving platform.

First install SCM on every computer with the following command: pastebin run 1kKZ8zTS
Next install this script with scm add elevator.
Server
On the server ([5] in image #1) run elevator serve <server_name>
Floors
On every floor run the command elevator floor <server_name> <floor_number>.

That's it!

You can now call the elevator to a floor by pressing the button on the computer.

To chose a destination you can click the desired floor on the monitor or type the floor into the computer.

The UI library can be changed within the config. You could even load it from a pastebin script!

For further documentation, please check the README.md in the default UI library.