search

me-no-dev / KissKONG

KissKONG - Next Generation KISS OSD
GNU Lesser General Public License v3.0
17 stars 6 forks source link

Support for KISSAIO(v1|CC)? #11

Open NeverFinished opened 7 years ago

NeverFinished commented 7 years ago

I'm using KissKONG with a KISSAIO(v1, 8A ESCs) / Firmware 1.2 (CC). I don't get any esc related information, like current / consumption. The status page doesn't show any information about the ESCs. I do get these information on SmartSport telemetry and in die KISS GUI. As far as I understand the code, there's nothing special to activate - as soon as the according ESC telemetry is transmitted it will be displayed, right? Or do I need to configure anything special?

lichtl commented 7 years ago

Have you bridged the telemetry pads on the bottom? AIOv1 require those to be bridged. Otherwise telemetry don't work. Are you receive details on the ESC section (serial number etc)

kiss-aio-v1_tlm_pin

should have read it better. So you get all information on the GUI (including serial number)?

NeverFinished commented 7 years ago

Yes, bridged. Firmware 1.1RC6 + ESC-FW1.08f did report current/consumption via smartport telemetry (XSR) back to the X9D, I didn't check the other telemetry values. Then I swapped out the XSR and added a non-telemetry spektrum receiver, and added the OSD (so I still would be able to see the battery consumption). Same firmware combination shows only voltage on the OSD. Then I updated to FW 1.2(CC) and ESC-FW108f-RC8(is that the same? weird naming. the right one from the same 1.2 package). Still only voltage in the OSD. I can see ESC RPM/current/temperature in the GUI, so I guess it's working in principle. I've seen the esc serial numbers somewhere, but can't see it right now. Which tab? Or is there some weird malfunction within the KISS firmwares? Usually all this should work out of the box :) Guess I have to add the XSR again and see what happens then.