search

mi0bot / OpenHPSDR-Thetis

Updated Thetis with support for Hermes Lite 2 functionality
31 stars 7 forks source link

[BUG] #86

Closed W5EIM closed 2 weeks ago

W5EIM commented 3 weeks ago

Describe the bug On Setup / Display / RX1 in the Waterfall area. Low Level is greyed out. Chaining the High Level does not change the levels displayed on the Panadapter

To Reproduce Steps to reproduce the behaviour:

  1. On Setup / Display / RX1 in the Waterfall area.
  2. Click on High Level and change the value and click Apply
  3. Scroll down to '....'
  4. See error

Expected behaviour Chaining the High Level does not change the levels displayed on the Panadapte

Screenshots image

Desktop (please complete the following information):

Additional context Add any other context about the problem here.

mi0bot commented 2 weeks ago

Switch off Waterfall AGC for full manual control.

ramdor commented 2 weeks ago

the high level is for the waterfall agc. To alter the spectrum/panadaptor spectrum grid you need to use min/max down below. The group box gives it away.

W5EIM commented 2 weeks ago

Good morning,

Referring to my problem of Thetis shutting down:

I built up a different computer with a new install of Windows 10. The computer was a 10 year old Intel NUC with an i5 processor so very slow.

I did experience multiple Thetis shutdown’s but am not sure that the cause were not just because the computer is slow.

Two of the of the shutdowns seemed to mirror the problem I am seeing on my primary system a two year old Dell i7.

My thinking is an intermittent hardware failure in the HL2 and have ordered a new one from Maker Fabs. I then will be able to compare and see if the problem continues.

Thank you for your suggestions for troubleshooting my issue.

Sincerely Dalton. W5EIM

Dalton Williams DeFever 41 MV Easy Living 20 Years & 34,800 Miles on the water Amateur Radio W5EIM Capital Yacht Club Member MTOA Member AGLCA Member

On Mon, Sep 16, 2024 at 9:30 PM Richie @.***> wrote:

the high level is for the waterfall agc. To alter the spectrum/panadaptor spectrum grid you need to use min/max down below. The group box gives it away.

— Reply to this email directly, view it on GitHub https://github.com/mi0bot/OpenHPSDR-Thetis/issues/86#issuecomment-2354328005, or unsubscribe https://github.com/notifications/unsubscribe-auth/BKSEMGCFAHWUTFE3XFTQX23ZW6AZVAVCNFSM6AAAAABOF64VVSVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDGNJUGMZDQMBQGU . You are receiving this because you modified the open/close state.Message ID: @.***>