A copy of the amiitool Lua wrapper is included at client/libluamiibo.so
, but if you want
to build it yourself, follow these instructions:
lua-lib
branch of amiitool at https://github.com/jamchamb/amiitool/tree/lua-lib.PROXMARK_LIBLUA
to the path to your proxmark3/liblua
directory../build.sh
and copy build/libluamiibo.so
to the proxmark3/client
directory.To build the main proxmark code, go to the proxmark3
directory and run make
.
Then flash the proxmark3 by:
make flash-all
Go to the client
directory and run ./proxmark3 /dev/ttyACM0
(or other device path)
and script run amiibo help
to list available commands.
Commands that perform cryptographic operations, such as read
, require a keyfile for
amiitool at amiitool_keys.bin
in the proxmark3/client
directory.
NOTE: For Switch system version 5.0.0 or above you need to provide the correct ECC signature for the tag. To do this add the 32 byte signature to the end of the tag dump file. The total file size should be 572 (540 bytes tag dump, 32 bytes signature).
NOTICE: (2014-03-26) This is now the official Proxmark repository!
INTRODUCTION:
The proxmark3 is a powerful general purpose RFID tool, the size of a deck of cards, designed to snoop, listen and emulate everything from Low Frequency (125kHz) to High Frequency (13.56MHz) tags.
This repository contains enough software, logic (for the FPGA), and design documentation for the hardware that you could, at least in theory, do something useful with a proxmark3.
RESOURCES:
This repository! https://github.com/Proxmark/proxmark3
The GitHub page http://proxmark.github.io/proxmark3/
The Forum http://www.proxmark.org/forum
The IRC chanel irc.freenode.org #proxmark3 -or- http://webchat.freenode.net/?channels=#proxmark3
The Homebrew formula repository https://github.com/Proxmark/homebrew-proxmark3
DEVELOPMENT:
The tools required to build or run the project will vary depending on your operating system. Please refer to the Wiki for details.
OBTAINING HARDWARE:
The Proxmark 3 is available for purchase (assembled and tested) from the following locations:
Most of the ultra-low-volume contract assemblers could put something like this together with a reasonable yield. A run of around a dozen units is probably cost-effective. The BOM includes (possibly- outdated) component pricing, and everything is available from Digikey and the usual distributors.
If you've never assembled a modern circuit board by hand, then this is not a good place to start. Some of the components (e.g. the crystals) must not be assembled with a soldering iron, and require hot air.
The schematics are included; the component values given are not necessarily correct for all situations, but it should be possible to do nearly anything you would want with appropriate population options.
The printed circuit board artwork is also available, as Gerbers and an Excellon drill file.
LICENSING:
This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 2 of the License, or (at your option) any later version.
This program is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for more details.
You should have received a copy of the GNU General Public License along with this program; if not, write to the Free Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
Jonathan Westhues user jwesthues, at host cq.cx
May 2007, Cambridge MA