protogasm

Software and hardware for Arduino-based orgasm prediction / detection ... on protoboard!

The nogasm is an amazing toy. I wanted to make something easier to hack and more accessible to the homebuilder. Fortunately headcrabned was kind enough to open source the whole thing.

I ported it the Arduino Uno, and hacked around on perfboard until I had it working. It works great and only requires a handful of readily available through-hole components.

Some aspects have been simplified compared to the original electronics:

• The DIP switches have been eliminated. Options are configured in the source instead.
• The RGB backlit rotary encoder has been replaced with a more common unlit one. The mode is still visible on the LED ring.
• It has more LEDs! NeoPixel Rings with 24 LEDs are the right size for the project.

Getting started

• RTFM
• Build the vibrator
• Build the control board
• Print the case for the controller

Fine print

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International Licence, available at http://creativecommons.org/licenses/by-nc/4.0/.