go-e Charger
Smart EV Charging from go-e
Adds support for the go-e Home and Gemini family of EV chargers for the Athom Homey Pro.
Setup
- 1st and 2nd generation devices must have fixed IP address.
- 3rd and 4th generation devices are automatically detected with mDNS-DS in the same LAN.
- API V1 must be enabled on the 1st and 2nd generation devices.
- API V2 must be enabled on the 3rd and 4th generation devices with firware 051.4 or above installed.
Supported devices
go-e Charger Home+
- 1st generation devices with serial numbers starting with CC1- (API V1)
- 2nd generation devices with serial numbers starting with CM-02- (API V1)
- 3rd generation devices with serial numbers starting with CM-03- (API V2)
go-e Charger Gemini
- 4th generation devices with serial numbers starting with GM-10- (API V2)
Supported flow cards
When
- Status changed
- Car connection changed
- Charging allowed changed
- Charging changed
- Delivered Energy This Session becomes greater/less than
number
kWh
- Supplied Power becomes greater/less than
number
W
- Supplied Current becomes greater/less than
number
A
- Supplied Voltage becomes greater/less than
number
V
- Temperature becomes greater/less than
number
C
- Charge Port Temperature becomes greater/less than
number
C
And
- Car is/isn't connected
- Charging is/isn't allowed
- Is/Isn't charging
Then
- Allow charging
- Stop charging
- Change current limit to
amperage
A
Example flows