search

pmqs / IO-Compress-Lzma

IO-Compress-Lzma - Perl5 module to read/write compressed lzma/xz/lzip data
4 stars 3 forks source link
compress lzip lzma perl perl5 perl5-module streaming uncompress xz

readme 

                        IO-Compress-Lzma

                          Version 2.213

                           28 August 2024

    Copyright (c) 2009-2024 Paul Marquess. All rights reserved.
      This program is free software; you can redistribute it
       and/or modify it under the same terms as Perl itself.

DESCRIPTION

This module provides a Perl interface to allow reading and writing of lzma files/buffers.

PREREQUISITES

Before you can build IO-Compress-Lzma you need to have the following installed on your system:

* Perl 5.006 or better.
* Compress::Raw::Lzma
* IO::Compress

BUILDING THE MODULE

Assuming you have met all the prerequisites, the module can now be built using this sequence of commands:

perl Makefile.PL
make
make test

INSTALLATION

To install IO-Compress-Lzma, run the command below:

make install

TROUBLESHOOTING

SUPPORT

General feedback/questions/bug reports should be sent to https://github.com/pmqs/IO-Compress-Lzma/issues

FEEDBACK

How to report a problem with IO-Compress-Lzma.

To help me help you, I need all of the following information:

  1. The Versions of everything relevant. This includes:

    a. The complete output from running this

        perl -V

Do not edit the output in any way.
Note, I want you to run "perl -V" and NOT "perl -v".

If your perl does not understand the "-V" option it is too
old. This module needs Perl version 5.004 or better.

    b. The version of IO-Compress-Lzma you have. If you have successfully installed IO-Compress-Lzma, this one-liner will tell you:

       perl -MIO::Compress::Lzma -e 'print qq[ver $IO::Compress::Lzma::VERSION\n]'

If you are  running windows use this

   perl -MIO::Compress::Lzma -e "print qq[ver $IO::Compress::Lzma::VERSION\n]"

If you haven't installed IO-Compress-Lzma then search IO::Compress::Lzma.pm
for a line like this:

  $VERSION = "2.213" ;

  2. If you are having problems building IO-Compress-Lzma, send me a complete log of what happened. Start by unpacking the IO-Compress-Lzma module into a fresh directory and keep a log of all the steps, including the setting of configuration environment variables (if applicable).

    [edit config.in or set environment varialbes, if necessary]
perl Makefile.PL
make
make test TEST_VERBOSE=1

Paul Marquess pmqs@cpan.org