Is there a way to re-initialize canopen_402 motor devices without unloading the controllers in the controller manager?
On a safety stop my motors are powered off, afterwards they need to be initialized again. This is possible by subsequently calling canopen_motor_node's /shutdown and /init service. However this unloads the controllers, in my case the joint_state_controller and diff_drive_controller. The latter will then have a new initial pose on re-loading it, resulting in a non-smooth odom frame.
Is there a way to re-initialize canopen_402 motor devices without unloading the controllers in the controller manager?
On a safety stop my motors are powered off, afterwards they need to be initialized again. This is possible by subsequently calling
canopen_motor_node's/shutdownand/initservice. However this unloads the controllers, in my case thejoint_state_controlleranddiff_drive_controller. The latter will then have a new initial pose on re-loading it, resulting in a non-smoothodomframe.