Ilovegym66
commented
6 years ago Hi, here the same, with 13 controllers, and regulary updates with iobroker the wifilight adapter hangs up, btw does not recognize that a device have to switch on. ( with Command or power-on flag ). After a restart of the wifilight adapter in iobroker it works for some time ( most 2-3 hours..) and than the same again.. I've a workaround, that I let it restart automatically all 4 hours, but this results in errors with the wifilight-adapter in iobroker, the adapter doesn't linke a restart here..
jogibear9988
have three controllers - all controllers are detected as HF-LPB100-ZJ200 it seams that my HF-LPB100-ZJ200 is LD868 (five channels) and the UFO HF-LPB100-ZJ100 (LD??? )
one Contoller is UFO with 4 channel RGBW (in MagicHome shown as version 3)
two Controllers are 5 channel with RGBWW (and same charge - in MagicHome shown as version 1) (https://www.amazon.de/gp/product/B01J5A7ABW/ref=oh_aui_detailpage_o09_s00?ie=UTF8&psc=1)
in ioBroker you can see the status change but one of the four Controller do not switch or only sometimes - the other one does. Sometimes the four channel Controller UFO works - sometimes not. the same with the four channel controller - one is working, the other works only sometimes even if status change is shown in ioBroker. port (5577) has to be correct because sometimes it is working. devicename: HF-LPB100-ZJ200' - port: 5577 Found that there is a possibility to switch between 4 and 5 channel controllers see here: https://github.com/steve228uk/homebridge-magichome/blob/master/flux_led.py
1.) why does UFO do not switch or only sometimes? (found solution - see below) 2.) why does one five channel controller switch and the other only sometimes? 3.) would it be possible do create a datepoint for cold white so that we have w (warm white) and cw (cold white) if it is a 5 channel RGB warmwhite coldwhite controller ? 4.) "ct" Paramater does not work (have one Controller with warm/coldwhite LED) 5.) Status of Pramameters show wrong values in ioBroker
I did a capture of the TCP traffic - Magic home sends "81 8A 8B 96" gets response and then the "on" or "off command "71 23 0F A3"
i modified the flux_led.py script and then the script was working too. But, did not test brightness and colors - if you need captures please tell me. I have the manufacture original docs of all command - if you need this, please tell me. "81 8A 8B 96" is a request of device status. I think in newer firmware it is a must that the device status has to be requested, before it can be switched on /off.
Could you please alter the Wifilight Adapter that it can handle controllers with newer software and the new 5 channel controllers.
by the way - with the magichome app its working all the time, so the controller hardware is ok thank you