search

sparkfun / 9DOF_Sensor_Stick

Product 10724 9 DOF Sensor Stick
https://www.sparkfun.com/
6 stars 4 forks source link

JP3 should be named JP1 #4

Closed ghost closed 9 years ago

ToniCorinne commented 9 years ago

So, fiducials, the logo, standoffs are all JP prefixes. Because of this, JP3 is actually JP3. Do we need to update all of those other prefixes to something else if we are not to use JP# for those then?

ghost commented 9 years ago

I'd swap the names for the fiducial named JP1 and the header named JP3 since the names for the standoffs or fiducials don't appear by default and won't be present in the pdf version of the schematic. The rest of the names can stay the same. It'll make more sense/look cleaner with that header named JP1.

mgrusin commented 9 years ago

At some point can we change the default designation for fiducials etc. to something other than JP? It causes a lot of dumb problems like this. Since it doesn't show up it could be FIDx, LOGOx, MIKEx etc.

-Mike Grusin SparkFun Electronics 303 284-0979 x 405 "This is only temporary... unless it works!" -Red Green

On Mon, Apr 20, 2015 at 9:42 AM, Kade notifications@github.com wrote:

I'd swap the names for the fiducial named JP1 and the header named JP3 since the names for the standoffs or fiducials don't appear by default and won't be present in the pdf version of the schematic. The rest of the names can stay the same. It'll make more sense/look cleaner with that header named JP1.

— Reply to this email directly or view it on GitHub https://github.com/sparkfun/9DOF_Sensor_Stick/issues/4#issuecomment-94487925 .

ToniCorinne commented 9 years ago

I personally agree with Mike, but I think that's a discussion better fit for the checklist repo perhaps?

Anyway, change was fixed and pushed for this specific board.