HeeksCNC

This file describes how to build and install HeeksCNC under Unix systems.

0. Requirements

To build HeeksCNC, you need to install these requirements (with develoment files)

• HeeksCAD
• OpenCASCADE or OCE (OpenCASCADE Community Edition)
• wxWidgets 2.8

1. Preparation

Create a build directory (e.g. build/ in sources root directory): mkdir build cd build

2. Configure build

If you want a default prefix (/usr/local) and a "Release" type, simply run: cmake ..

If you want to change install prefix (e.g. /usr): cmake -DCMAKE_INSTALL_PREFIX=/usr ..

If you want to debug HeeksCNC and its install: cmake -DCMAKE_BUILD_TYPE=Debug -DCMAKE_INSTALL_PREFIX=$PWD/install ..

Important note: HeeksCNC's prefix should be the same as HeeksCAD to work correctly

3. Build

After a successful CMake configuration, you can build using: make

If you want more output (ie. to debug): make VERBOSE=1

4. Install

Using default or system-wide prefix: sudo make install

Please note that if you installed it in /usr/local, you may need to run: sudo ldconfig

If you choose a user-writable prefix, superuser privileges are not needed: make install

5. Run

HeeksCNC is used through HeeksCAD interface. HeeksCNC requires additional python modules at runtime:

• python module built by libarea
• python module built by opencamlib

X. One-liner snippets

Default: mkdir build && cd build && cmake .. && make

Debug: mkdir debug && cd debug && cmake -DCMAKE_BUILD_TYPE=Debug -DCMAKE_INSTALL_PREFIX=$PWD/install .. && make && make install LD_LIBRARY_PATH=install/lib install/bin/heekscad