search

tckb / FlashForge_Marlin

:shark: Marlin firmware for some FlashForge 3D printers
1 stars 0 forks source link

Test Marling firmware in Flashforge Dreamer #13

Open tckb opened 3 years ago

snotten commented 3 years ago

Total n00b, but have a Dreamer. Let me know if I can (try) to do something =)

tckb commented 3 years ago

hi @snotten thanks for your help! I need help in testing out the firmware on Dreamer. Check if the firmware works. as expected Follow the steps at https://github.com/tckb/FlashForge_Marlin/wiki to install the latest release. Thanks@

snotten commented 3 years ago

Sure thing! I'm running moonglow's release atm, with swap so I dont get confused in the simple things ^^ I will try yours after an failing print, my bed is crocked AF :/ :D

tckb commented 3 years ago

sure, no problem. thanks for the help! my configurations are a bit different from moonglow. Though, I haven't updated it in a while.

snotten commented 3 years ago

Allrighty! Just as info, for with moonglow's release, the left extruder was inverted with extrude/retract - solved by turning the connector 180 degrees =)

Tried your prebuilt, both extruders was extruding. Just not swapped, but I didnt expect them to be either =)

Connected with OctoPi also, no message about "Marlin: Uncomment #define HOST_ACTION_COMMANDS in Configuration_adv.h" - dont really know though...

I will soon upgrade to removable glass/magnetic bed - my plate is impossible... Especially with two nozzles, one prints and the other teares ^^