Marlin 2.x Firmware for Flashforge 3D Printers
Current firmware is based on 2.0.7.2
What works?
- [x] TFT display ( ILI9488 and OTM4802 )
- [x] Touch screen controller ( XPT2046 )
- [x] Chamber and bed temperature sensors ( internal ADC )
- [x] Extruder K-type thermocouple with external ADC ( ADS1118 )
- [x] Chamber RGB light ( PCA9632 PWM controller )
- [x] Stepper motor current setup ( MCP4018 digital potentiometer )
- [x] Print cooling fan, chamber fan, endstops, stepper motor signals control
- [x] External SD card
- [x] USB ( virtual serial port )
- [ ] Internal storage ( read discussion)
- [ ] Power-loss recovery (read discussion)
Unsupported
Head on to the wiki page to find more details on flashing the firmware, building from source etc.
Supported platforms:
The scripts are written to work well with the following platforms -
Supported printers:
- DreamerNX
- Dreamer (Untested)
- Inventor (Untested)
Want to support me ?
Credits
- This repo is a fork of the excellent effort made by @moonglow, consider supporting his work.
Disclaimer
All though the firmware might work on the supported printer just fine, I still require testers to confirm. Please exercise your own judgement on using it. I am not liable, nor I bare responsibility in the event of a failure but, I will support you in fixing should there be any problems.