-
Hello.
I have an issue using GNSS sub-module.
As I understand, to use the GNSS I need to enable 1.8V FET switching GPIO5 to ON state (according to your schematic). But when I try to do it, I g…
Hvunt updated
9 months ago
-
Hello, with what code file did you achieve a consumption in standby mode of 125 uA. I arrive at 175 uA but when I ask for a wake-up call 20 hours later I always have a moment after a few hours where t…
-
I'm using the HttpsClient example authored by @Sukaibin11 . Board A7608E-H with latest firmware B08.
I think that
`
http.connectionKeepAlive(); // Currently, this is needed for HTTPS
`
Doesn't r…
-
I'm using the TinyGSM_Net_GNSS example. The reported coordinates are wrong when the decimal part of the latitude has leading zeroes, because they are omitted. Example (edited for privacy reasons):
…
-
Hello!
I have two Lilygo A7608 boards. And there is a problem with connection (on one of them) - it is very unstable and reconnect often, while the other works much much better.
Normal board:
…
-
I've brought [T-A7608](https://www.lilygo.cc/products/t-a7608e-h?variant=42860532433077) without GPS antenna. But I want to try using external antenna to test the GNSS feature, but when I try to use t…
-
The T-A7608 (https://www.lilygo.cc/products/t-a7608e-h)is powered via usb and the installed battery is charged. When the battery voltage reaches 4V I switch off the usb power to protect the battery fr…
-
Hi, when I powered A7608E-H from Usb C cable I got an accurate values on 3.55, but when switched into battery source (18650 3.6), then the values are not even close.
How should I get this value? Is …
-
Hello,
I have one question about this library. Does it support A7670E gsm module? I have shield for raspberry (which can be used with esp32 aswell) with this modem. And problem is I cant make it work…
-
It might be that I'm missing something.
Using the supplied test site, same as on the lilygo repo, worked fine:
```
const char* server_name = "vsh.pp.ua";
const char* path = "TinyGSM/l…