-
**Describe the Enhancement**
Add driver code for the [Adafruit BME280](https://www.adafruit.com/product/2652) sensor. The driver code will read temperature/pressure/humidity and upload it to the Dirt…
-
Hi. I want to use this crate but it seems that `ìnit` needs a delay provider.
```
bme280::i2c::BME280
impl BME280
pub fn init(&mut self, delay: &mut D) -> Result
where
D: DelayNs,
// …
-
**Describe the bug**
havent read the log yet, its a crash
**To Reproduce**
Steps to reproduce the behavior:
1. it kinda happened after running for a while i havent debugged idk
2. in stem cente…
-
is my sensor broken or is the firmware not measuring correct?
https://github.com/arendst/Tasmota/issues/1051#issuecomment-1288423223
dr-ni updated
2 months ago
-
Hi,
Thank you for making this, Installers just put in a Lossnay system in my house with a ducted system but they only hooked it up to power. So really it is not doing anything! I really think they d…
-
Hello Mr. Powell and the community,
on the '↑+0' menu I found a submenu named 'Weather'. If this submenu is chosen there is a message that states that the BME280 is not present.
I couldn't find a …
-
I'm trying to connect a BME280 sensor to Heltec WSL V3 using pins 3.3V or 5V, GND, no. 41 and no. 42 - instead of telemetry there is "g...t...r...p...P...h.. b....". When I connect the same sensor to …
-
I have tested the simple example for SPI using the same BME280 you recommended.
It is not working - the error is "unknown model"
Linux kernel: Linux 6.6.31+rpt-rpi-v8 aarch64
Setup using r…
-
Hi All,
i have connected BME280 sensor to Flipper Zero. It shows temperature and humidity fine but for pressure it only shows one value - 734 mm/hg. I have connected that very same sensor to Raspbe…
-
Does it make sense to add an BME280 (temp, hum, pressure) to the board:
- high quality and low power sensor
- good to monitor the inside conditions of the board
- Easy start with some hardware di…
jdede updated
4 months ago