-
Write a CANMod class to read the data from the CAN bus, separating into GPS values and the IMU data.
-
# Feature Description
- **Expected implementation date:** 2024-11-9
- **As a:** Developer for omnibus,
- **I would want to:** generate fake GPS CAN messages from the parsley source.
- **Because:*…
-
Add your issue description here.
*If possible, upload an example that shows your problem.*
I now have some GPS data for the bus, which contains the route number, latitude and longitude of the bus.…
-
Extract GPS NMEA data and display it
Extract if available, maidenhead grid square location (on CI-V bus?), else calculate it from NMEA data.
-
### Describe the bug
When PiZero2W is connected to an icom705 (ham radio) via USB, the following command instantly locks up Raspberry Pi OS Bookworm, with all patches applied. Console unresponsive, n…
-
I was not able to get any GPS readings. I am using:
CAN-BUS Shield (DEV-13262) and GPS Receiver
EM-506 (GPS-12751) ordered bis SK Pang
Arduino Uno R3
Looking at the hookup guide, it actually see…
-
### Describe the bug
This board runs without issues with `stable`, somewhere in-between caused the following to malfunction:
- Compass is not correctly detected, it receives data and it's possible…
-
Hi! I'm currently building a new dashboard app based on the SuSoDevs one and your project.
I've found that bytes 1 and 2 in the 0xAADA message (Current drawn by the controller) have the unit 0.1A; e.…
-
It's great job, but comparing to first version, I'm unable to use my /dev/ttyACMX (last number may vary depends of use additional USB modem) device(ID 0e8d:3329 MediaTek Inc. Qstarz BT-Q1000XT [MT3329…
-
# Reading in the bus stop coordinates from the dictionary "BusStopLocationsMap" (in ImportSchedulePage.xaml.cs at lines 26 and 204) into the bus stop objects.
The dictionary "BusStopLocationsMap" …