-
Hello @calohmn ,
I am trying to connect to Hono MQTT adapter from my M5core 2 device for updating telemetry data like temperature mentioned in cloud2edge tutorial , where Hono is running on Kubernete…
-
# Neopixel_board
本例程使用的是24x8阵列的Neopixel RGB LED
This example uses a 24x8 array of Neopixel RGB LEDs.
需使用M5Core + M5GO 底座驱动Neopixel灯板
Need to drive Neopixel light board with M5Core + M5GO base
…
-
The Gesture code, and other touch code is missing from Unified for M5Tough.
-
Instead of \ my Cardkb hats output / if the second from the right button on the 4th row labelled \ / = is pressed.
If your atmega firmware is the culprit, I need a fixed firmware and instructions ho…
-
I try to flash my new M5CORE modul:
```
Type: 35
2019/08/19 17:15:39 detaching board ...
2019/08/19 17:15:39 closing serial port ...
2019/08/19 17:15:39 stop inspector ...
2019/08/19 17:15:40 …
-
### The problem
Following error shows soon after boot:
`[E][display:109]: Could not allocate buffer for display!`
This looks very similar to https://github.com/esphome/issues/issues/4315 except t…
-
I have a working code that supports M5Stack Core2. A couple of things require design decisions to make the cfGUI library compatible with Core and Core2 (if both should be supported by the same code ba…
-
### Describe the bug
M5 Core 2 module was working normally out of the box using the default firmware.
I tried the example arduino code found here but it would not compile, after installing the nee…
-
The A,B,C buttons don't appear to be working on M5Stack Core2.
-
### The problem
I'm trying to use an M5Stack to read the temperature from two Xiaomi Mijia sensors. I can create a minimal yaml which successfully reads the temperatures and relays them to an instanc…