-
### What happened?
zigbee2mqtt throws an exception when trying to configure my Aqara Smart Radiator Thermostat E1.
Yesterday it was able to read values from the radiator but not write to it. Now,…
-
I'm configuring my home Node-Red system to run on two Raspberry Pi4 machines, under K8s/Docker containerisation in a high availability mode. I can come up with a solution for most of the potential iss…
-
![want-you](https://user-images.githubusercontent.com/8080177/206915216-49011ad2-0374-492d-809c-3f5f94b9f100.png)
I would like to know how people are using this software. As I have developed a lot …
-
Hi, i have the same heater, ariston Genus one. What device should I buy to read data via ebus? Is it 2 way communication? I have ethernet near heater. Will appreciate help!
-
Hi there, really cool that you managed to figure all this out.
I'm trying this on a B21, and when I try to print an image with a width of 96px, it comes out in the center of the label, rotated the …
-
How do we change the sensor names? For example how to change garage-sensor-1 to garage-fermentation.
-
# ESPAltherma Community post!
> ESPAltherma is used all over the world! well... mostly in Europe... mainly in Germany ;)
> Let's show each other what we did with ESPAltherma!
> This will be nice …
-
can use the Visual Studio Code on a ipad
-
I have been wondering why the following occurs on my Windows 10 laptop and the Pi USB.
I am using a 128G SanDisk Extreme Plus UHS so I would think it rather fast.
I put in an old "slow" USB stick…
-
In colder climates the printer (MK3) powers up and goes to error min bed temp. After heating the bed with a hot air gun it clears to hot end min temp and after a little heating so does the hot end. I…