-
```
Alex Sir,
Pls. port your code to Arduplane 2.68, lot of people would love to use.
BR
VU2AT
```
Original issue reported on code.google.com by `vu2...@gmail.com` on 20 Dec 2012 at 2:31
-
in standard openscad
* a cube has a corner at 0,0,0 ; with center=true, it is centered about all axes
* a cylinder is centered on x and y, and also on z if center=true
* a sphere is centered at the…
-
```
Alex Sir,
Pls. port your code to Arduplane 2.68, lot of people would love to use.
BR
VU2AT
```
Original issue reported on code.google.com by `vu2...@gmail.com` on 20 Dec 2012 at 2:31
-
```
Alex Sir,
Pls. port your code to Arduplane 2.68, lot of people would love to use.
BR
VU2AT
```
Original issue reported on code.google.com by `vu2...@gmail.com` on 20 Dec 2012 at 2:31
-
## Expected Behavior
Package should be installed from RPM
## Current Behavior
```
# rpm -U ./expresslrs-configurator-1.4.2.x86_64.rpm
error: unpacking of archive failed on file /usr/sh…
-
This was originally posted on DronesDiscuss but I never got a reply, I apologize for the cross post.
Is there any interest in code to support a twin motor airplane? I have flown the Twinstar for yea…
-
Dear Kris,
thank you so much for this beautiful library!
Anyhow, I have a small question. I only need acceleration data in my project, but I don't know how to calibrate the IMU.
my Code so far:
…
-
Hello jeanrocco,
Your display solution sounds great!
Are you running a MQTT broker to that the autonomous portable temperature display subscribes to, or does the ESP8266 subscribe directly to t…
-
### The problem
Changing the set-point in the PID-controller caused the derivative term to see a change, and pull the output hard in the direction the change was in.
I'm working with 30 seconds of…
-
Why when I use angle mode during idle, the PID doesn't work and I can't use pitch, roll, and yaw for control? But when I use althold mode during idle, the PID does work?I use multicopter.