-
Hope you are well .
I have the issue connecting xpro V5 with vfd hy02d223b .
Have separated RS cable from rest of the cables to avoid interference .
Spindle can be controlled manually but not vi…
-
Hello, first, sorry for my bad english, but I've some issues i don't understand.
I've got a 3d-Printer with the BTT SKR Pro V1.1
I've installed 4x TMC5161 and configured them as followed:
Confi…
-
/*
xboard_e01.h
Part of Grbl_ESP32
Pin assignments for the XBoard E0.1.
2018 - Bart Dring
2020 - Mitch Bradley
Grbl_ESP32 is free software: you can redistribute it …
-
Manta M8P with HermitCrap V1 was working fine with microprobe V1.2. After the pin get damaged and replaced with microprobe V2 it keeps given the some error, "Endstop z still triggered after retract" t…
-
I am trying to use this "Software_SPI" example, but i have tried others as well I found on the net and absolutely nothing I do will make my motor spin.
Can someone please help me figure out why. This…
-
Hi all,
I have a workbee cnc that I originally purchased with an NVUM controller, I was having issues with it and opted to switch to an xPro when it was released. I've had it about a 9 months, set …
-
Ok, I just assembled my Ultimate Bee 1500x1500 ball screw. It has 4 Nema23 steppers. I updated the firmware to CNC_xPRO_V5_XYYZ_BM3D_NC because I have the emergency stop button. When I try to move a…
-
Hi,
Probably I am in the wrong section- it is not an error/issue- but here goes
The Trinamic Evaluation, BOB and now also the stepsticks have pins for end stops on them (aliexpress)
How can acc…
-
Hi,
Currently developing board based on tmc2160, losed tmc5160 because it pointless without supporting encoder feedback on marlin side. So, to reduce amount of wire i decided to make uart-spi bridge,…
-
Hello, i cannot configure my printer to home with this script.
Here's my config:
```
[autotune_tmc stepper_x]
motor: moons-ms14hs5p4150
tuning_goal: auto
sg4_thrs: 45
voltage: 24
extra_hyst…