-
Issue for discussing adding support for the Z80 remapper for the Cirtech range of CP/M cards.
(see also notes on the remapper https://github.com/peteri/CirtechCPM/blob/main/src/address-map.md for the…
-
`sdcc -mez80_z80 -O2 -c inet_aton.c`
```
inet_aton.c:134: error 9: FATAL Compiler Internal Error in file '../../../src/z80/gen.c' line number '8374' : Unimplemented
Contact Author with source co…
-
## Create the SD Card Image
**!!! WARNING !!! This process can damage your host file system if you get it wrong. Make sure you only format the loop device after setting it up.**
This step is a b…
-
I tried building release-6-0-pre-5 (via git clone, and via the zip on the releases page, and via the tar.xz).
Build succeeded but then it seems to be missing 8080 support (i80).
```
bash $ …
-
hi. don't know how to write to you in another way.
in your opinion is possible to build a .z80 loader? for the porpuse maybe only 512bytes of the initial rom could be enough so you can freeup some pi…
-
z80 and gb have a very similar CPU, we should share code, or at least make z80 at the same state of the gb one, because anal, and disasm fails a lot with -a z80, and the same goes for the assembler
-
The code base currently sports three different Z80 cores. Discuss with Miguel how to proceed.
-
When disassembling code that contains undocumented Z80 machine instructions, they are skipped by the disassembler. For example
* 0xfd 0x7c
* 0xfd 0x25
They are documented in http://www.z80.info…
-
Detect R800 mode before detecting the EPCS4 device and switch to Z80 mode in C2FWUPD utility. In R800 mode cartridge is unstable and updating the firmware may be risky
-
Rom works fine on wabbitemu (it's a ti 84 se rom), but I open it on this emulator and this happens:
I can exit pressing esc, but that's about it.
I'm using a ti nspire cx ii cas with ndless 5.3
![W…