-
Hello everyone. I would like to create a "4th axis" using the extruder stepper motor. In the current 3D printer setup, we have the XYZ positions using either XYZ min/max pins. I would like to use one …
-
why my gcode that i created is like this did i do anything wrong?
-
I've downloaded your code and I'm trying to figure out how I might go about adding support for the TCM2130 Silent Stepstick drivers. I've got a few from other projects and they have some very nice fea…
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
VMWare running Hassio with esphome ESPHome 1.12.2 add-on
ESP8366, Wemos D1 mini with shields stacked.
WS2812B RGB shield - hw-7…
-
Hey,
I am using 2.0 bugfix from 6/26 on an skr 1.3. with tmc 2130. it's a Delta printer. Done a lot of googling but could not find a solution. My prints are coming out beautifully with the exceptio…
-
Hi,i have new stepper driver dvr8825 but if i engrave 40x40mm size final product is cca 20x20mm
If use stepper driver A4988 engraved size is ok.Please how to set DVR8825?
Thank you.
-
I have a chinese 16w Laser Engraver which came with Benbox to install which worked initially with NANO(324p)/LX-Nano with a CH340 chip but now the command buttons will only move the Y axis one way or…
-
Any plans to support stepper motors, especially driver mode?
I have an Arduino johnny-five project I'm looking to port to a Raspberry PI.
-
Today i finded this terrible bug, that makes my machine inoperative.
For some strange reason, if you add to the firmware the config options of a delta, and enable big things that costs a lot of memor…
neox3 updated
4 years ago
-
Hello!
I have a problem with my laser I cannot figure out for long time.
I have a laser which works (burns) when I switch it on without any control.
When I connect the laser to CNC Shield and start…