-
Hi! I plan on modifying the battery from 10s3p to 10s5p by adding two more LG M26 cells in parallel for each of the ten groups of three paralleled cels. The resulted capacity of 13 Ah would be managed…
-
I am plan to diy this wonderful arm, but I am not found stl for right leg.
-
If you're not sure what settings you're supposed to use for laser engraving or cutting something, the recommended procedure is creating a 2D grid of squares, with each row being a different power leve…
-
I'm working with the laser cutting (NHS visors) this evening, David and I noticed the laser is set to 100% power and the advisory sticky note says it should be 70%.
Please could the relevant person…
-
I am new to MFEM. I'm trying to figure out how to create a time-dependent heat simulation with Neumann boundary conditions. My input is a 2D tri-mesh. The initial condition is constant temperature thr…
-
Hi,
I found this function in the documentation:
> **exportSvg(fileName)**
> Exports the first item on the stack as an SVG file
> For testing purposes mainly.
> **Parameters: fileName** (Strin…
-
Hi, I wonder if anyone can advise.
I have several instances of ‘unsupported command’ when I view my Gcode in LaserGRBL.
I will attach a couple of photographs but I am wondering whether it explains s…
LJg81 updated
4 years ago
-
Hello, at first... sorry for my bad english
I have a new toy. A Totem Laser engraver and i have one Problem only at vector laser cut.
I hope you can see the problem and know what i mean.
The lase…
-
klipper uses standard trapezoid acceleration as far I know. I never seen a firmware with s-curve like acceleration and I think it would work better for printers
Some video from https://www.youtube.co…
-
A clip holding down the tube feeding Gerald's air assist had failed. As a result the tube sprang up and got in the way of the laser beam.
The tube burned though and the air assist failed. One symptom…