-
Dear Pham!
Thank you for all your efforts to share your experiences with LoRa technology.
Using the provided documentation and software I managed to create a working setup on 868MHz with a RPI3+[c…
-
I have received a request to allow failsafe to be disabled entirely - no safeguards on the channel values, no fallback values in case of signal loss. Just allow FC to always trust the data that's comi…
-
Hi, I have a question.
The node cannot receive the ACK sometimes when it sends a confirmed data message to Gateway nearby. I find the RSS and SNR values(uplink) are satisfactory. There are several …
-
Startting Failure
C:\Users\XXX\Desktop\Sketch\libraries\arduino-lmic-master\src\lmic\radio.c 689
I have tried with 1.6.10, 1.6.11 and latest version of arduino.
radio.c code which i am using …
-
Hi all,
I received the downlink frame but I would like to measure accurately the time betwwen the end of an uplink and the start of RX window.
The goal is to check that RX1 is opened after RX1_R…
-
Hello, we are opening your example (same applies for file sync and realtime example) and we are getting this error:
Please take into account that we modified the source according to issue #12 in ord…
-
Is it possible to add experimental ISM band for Russian Federation?
All parameters are the same as in band_eu863_870.go except frequencies.
Ch# Freq Modulation duty cycle …
-
Hello,
I have detected a problem with my RFM22b on the Chistera using lora_chisterapi as a receiver.
- I send 10 bytes frames (0x00, 0x01, ... 0x09) with a TeensyWiNo using the code attached "r…
-
My radios seem to need more time establishing LoRa,begin(); So I just add the call before the if statement. Am also getting some garbage. Not sure what the cause is. Using this Dorji radios: htt…
-
As running nurses based code and in particular ensuring it starts at boot time, which typically requires the use of 'screen', it would be great if it was possible to have an option to start the gatewa…