-
Dear Mirek,
I noticed that the number of tabulated lines is higher than the number of lines used for the refined wavelength solution.
I assume this is due to sigma-clipping.
Is there information …
-
Solar Orbiter EUI data JPEG2000 files are now available. I heard yesterday that they are being copied into the Solar Orbiter servers at the SDAC. These images are already available via JHelioviewer if…
-
### Version
2.3.57
### Operating system type + version
Win10
Working With Calibration Objects
Temp Tower, 2-,2+ Steps 10
Get "ERROR: First Layer height can't be greater than perimeter extru…
-
Sometimes design constraints prevent magnetometers to be placed further away on the vehicle and there is a clear correlation between vehicle throttle demand or measured vehicle current and mag hard ir…
-
Hi,
We are calibrating some SCD41’s together in a fixed CO2 environment (500ppm). After calibration we noticed big differences between the sensors.
In the datasheet:
“ 3.7.1 perform_forced_re…
-
Hello! Thanks for a great project! :)
I'm trying to make it work on my rooted lg tv using esp32 dev kit with CH9102F usb2uart chip, which is supported natively by tv os.
But it doesn't work some how…
-
modbus_set_slave() disallows Slave IDs above 247. A particular modbus device that I am using defaults to a slave ID above 247 (specifically, 254) and does broadcast on IDs 255 and 0. This means that I…
-
I've just provisioned 2 of the enviro indoor sensors and one of them is reading a good 4-5C above what I believe the room to actually be, is there a way of calibating the sensor or, alternatively, a w…
-
One of the new replacement collimators was installed for the night of 2022-04-13 only, on SP1 (SM10). It has a deep absorption at 420 nm, which is bluer than the dip in the original collimators. Onl…
-
1) Bulk Download Tool->Export Calibrations with Configurations and Constants results in the error file below.
Error: MODE: "part has calibs ONLY" is not true. The part has constants defined.
2) Bu…