-
I do not understand where is error.
I have two identical extruders (MK8).
when I say to repetier extrude 10mm, 80mm comes out (the first extruder is ok).
is there anyone who can help me?
thanks
-
Hi!
I'm quite new on the 3D printing world so please excuse my stupidity....
I've been doing little research on this board (Due) and is meant not to have EEPROM however the marlin firmware for Due d…
-
Hi, I did this post on the reprap forum, but after a couple of posts nobody seems to find an answer for this strange behaviour:
http://forums.reprap.org/read.php?13,358655,373531#msg-373531
The thin…
-
I have painstakingly extracted the pin configuration from g2Core for the Printrboard G2 and created a Marlin 2.0 pin file, I don't know what to do next. I understand its a DUE processor and is from th…
-
I have read the FAQ.
It'd be a nice-to-have if the temperature graph was able to display power output levels returned in Repetier firmware (perhaps Marlin too?)
Temp format for a single head pri…
-
Hi, I have a ramps 1.4 with drv8825 (32 microstep) mounted on a home made printer for laser engraving.
I have repetier-host 1.0.6 on windows 7 x64 and the gcode file is about 80MB.
With 10000mm/s² of …
-
After a long overnight print finishes, it'd be nice if the ATX power could shutdown automatically after an idle timeout. I suppose I could solve this with Gcode postscript too, of course, but I used …
-
This issue is intermittent - sometimes it seems permanent like now.
Print quit with this log:
```
16:02:21.613 : echo: M301 P21.96 I1.86 D64.76 C1.00
16:02:21.613 : echo:Filament settings: Disabled
…
ruggb updated
2 years ago
-
Hello!
My Prusa i3 (Arduino Mega 2560, RAMPS 1.4, Extruder-Fan-Bed config, Ultipanel) worked fine with Marlin v1. I updated to Marlin v2 (OK), then I uploaded Repetier for a test but decided I prefe…
-
Hello everyone,
I am a beginner in making 3D printers and I used Ramps 1.4 Marlin Firmware 1.0.2.
I have a problem communicating with sw Pronterface and Repetier.
When I use the Arduino sw communica…