-
Hi, all!
I have problem with configuring Repetier firmware for such configurations.
I've set pins properly, and created Configuration.h, but it ignores motion on X,
puts motion on Y to X axis motor dr…
-
Hello,
I want to use moveit control the ur5 robot, so the environment configured as follow:
1. Ubuntu 2204
2. ros-humble version
3. use ros-humble-ur driver, Universal Robots ROS2 Driver (install…
-
### Did you test the latest `bugfix-2.1.x` code?
No, but I will test it now!
### Bug Description
Dual Z Stepper works bad on Geeetech GT2560 rev-A+ board
### Bug Timeline
At first attempt with du…
-
I installed a S42B on the X-axis of one of my printers which has a SKR 1.4 turbo board and Marlin-2.0.5_7_7_20 installed and was working fine on a 2209 driver. Calibrated the S42B OK, commented out th…
-
I am working with an ESP32 and I am using MicroPython on the ESP32. I have not come across a working library for the mpu9250 sensors. I have ported the library you have written to Python. It does run …
-
Hi, I created a small sketch that allows grbl to function without PC , you need :
2 arduino ( 1 for GRBL, 1for control )
1x LCD shield
1x SD shield
https://codebender.cc/sketch:119423
then I include…
-
Greetings, thank you in advance for your dedication. This is my first time posting here, bear with me if additional info is needed. Quick backstory. I'm playing around with a Johnny Five Inventors Kit…
-
### Wiki Search Terms
HBridge M3 and M4 rotate same direction
### Controller Board
TinyBee
### Machine Description
Experimental DIY 2 stepper axis, one servo, one H-Bridge DC motor
### Input Cir…
-
I am experiencing a desync issue with 2 of my quads. Both are running DYS ESCs. I can get either one of them to do it on command by perfoming a quick roll. Both quads are on betaflight 2.7.1 and BLHel…
-
I have a Keiser M3 which is very close to the M3i only without Bluetooth. I am considering adding support for it, which would involve
- bringing the flywheel speed sensor (switch closure) to GPIO p…