-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
With marlin 2.0.9.2 there is no problem.
After install marlin 2.1.2 or 2.1.1 , E0 extruder m…
-
### What happened
There is an inherent problem when using a system that can only add or replace values, as you can't remove a key-value pair once introduced. This means that for every option that re…
-
Hello Terjeio
I bought a TinyBee v1.0 and I test it before mounting in my CNC, Wifi, Webui, SDcard, 5 axis, 3 limits + probes are OK.
Firmware downloaded yersterday, last IoSender
I enabled VF…
-
### Did you test the latest `bugfix-2.1.x` code?
No, but I will test it now!
### Bug Description
I am trying to configure my Octopus V1.1 with two independent Z-Axis Motors and two Endstops.
…
-
Upgrading from SKR 1.4. TMC2209 on all axes. Installed all jumpers according to manual.
Sensorless homing not working.
Send: M122
Recv: X Y Z E E1
Recv: Address 0 0 0 0 0
Recv: Enabled fa…
Drzet updated
2 years ago
-
I have MKS Robin Nano v1.2 with all 5 TMC2209 installed with soldered jumper wires (as in this video: https://www.youtube.com/watch?v=7ShcFKXrVHo) (fifth slot previously has TMC2208, I switched to TM…
-
Using Bigtreetech tmc2209 driver with a ramps 1.4 board. The modifications I've made to TMC2209 Stallguard Example have been: uncommenting the ISR timer lines(except for the STEP_PORT ^= 1 line) and u…
-
Hi:
I'm now try porting tinyG2 edge branch to STM32F415 MCU.
i use USART to communicate with PC.
I have some questions:
1) the MoatateBuffer: the RXBuffer to start transfer, it call …
-
Hello,
My SKR Mini E3 keeps disconnecting from any USB Device after about 15 seconds. Tested on Windows PC and Octoprint. In Windows, the board shows up and connects normally but after 15 seconds i…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Running Marlin 2.1.1.
Also tried Marlin-bugfix-2.1.x.
Machine is a Ender_3 with BTT_SKR …