-
I am a newcomer - first off, thanks for the project! It looks very useful. Knowing the rigor of the DYI audio community and the shear issue count, this tool looks pretty mature.
I recently picked u…
-
when I try to compile a .ll file with the line
`%vpadd_12v = call @vpadd_i64x4( %sum.0, %38)`
I get the following error
swpp-compiler crashed: exception thrown from backend
unable to pars…
-
The second 56uF cap on the 12V MR line is needed for the ETB driver - we can replace with much smaller value cap on the brain, and move 56uF to adapter boards that have ETB
-
Clip leads are dangerous.
I'm assuming the 12V was used for the RTC because 5V wasn't always 5V and would have made the battery more difficult to charge. Or because Commodore being cheap, didn't wa…
-
** Append Logfile **
[logfile.zip](https://github.com/bassmaster187/TeslaLogger/files/11882382/logfile.zip)
**Describe the bug**
When Teslalogger is on, the Battery has an excessive recharge …
-
Hi
Thanks for designing this.
The Cout caps in the 12V BOM are listed as being part C2012X7S1A226MAC. However that part is only rated for up to 10V.
-
- [ ] move the J1 connector by 1mm to the edge
- [ ] R104 = DNP or add divider, now LM75 is pulled to 12V
- [ ] add arduino series resistors (nano every has 5V IO)
-
Continuing the conversation from:
https://github.com/EnviroDIY/SensorModbusMaster/issues/21
There is a need for an updated [RS-485 Half Shield](https://www.envirodiy.org/product/envirodiy-rs-485-h…
-
The 12V LED keep on even Boost_EN low.
It should be better by using Boost_EN pin drive the LED.
or
Add a PMOS/Load switch on 5V before Boost IC Vin to totally cut off the supply.
-
The +/- 9V DC to DC converters are becoming very difficult to procure; suggest changing to +/- 12V 1W converters instead, ensuring 4.7uF capacitors are appropriately rated. The Op-Amps can operate wit…