-
Hello,
I'm having trouble visualizing how to create this template/layout for SpineOMatic and am hoping you can give me some help. This is a three-label set, with a spine label on one side and two "…
-
This issue is collecting my understanding of the design of Lazy under Multicore.
## Sequential Lazy
With Sequential OCaml, trying to force a value that is currently being forced raises Undefined…
-
Hi, first off, thanks for these guides, they're great and really helped me out.
I had some trouble getting things to run, though, and wanted to share my fix. Basically, I had to add a -mtriple flag f…
-
Has anyone done a zero crossing mod for switching the cooling fan? Either by replacing the triac driver with an inbuilt zc or by using the 9vac as a zc measurement input? Any suggestions?
-
I noticed that when probing the axis doesn’t stop right away after a touch has been detected. I measured it and it goes for approximately 500ms after probe has touched. I test an Arduino GRBL and it g…
-
I'm not sure is this installer problem or partition manager issue, however after reformating partitions and creating
software raid 10, md1 device started resyncing and then this problem occurred and…
-
Hello,
I believe I have bricked my Teckin SP20, very similar to this issue: https://github.com/ct-Open-Source/tuya-convert/issues/650
The mac address reports as being Espressif Inc.
I can …
-
I am currently trying to use a gShield on an Arduino Due running g2 for laser engraving. Cutting works quite well by using PWM and Spindle Speed Control for enabling/disabling the laser.
For engrav…
-
Lots happening each day. Good time to up the coordination. Striking a balance between enough to get in a row but not too much that it cripples progress is always a tightrope.
Proposing that @ajlen…
-
Hi,
I want to build a battery powered moisture sensor with an ESP32.
As it is battery powered I'm putting the ESP32 into deep sleep and power it up once every hour to save energy.
I noticed that th…