-
Is there any way to get my esc's back?
-
A big thank you for the improved data you can see in the two charts below! The first one is using 32.8.1.2, and the second one is using the (improved) beta 32.8.3; all the firmware settings were (almo…
-
**Enable 3D mode for quad copters**
I know that there is a DShot_3D_enabled (https://github.com/PX4/PX4-Autopilot/pull/17488), however this does not seem to be fully implemented to me. The throttle s…
-
I have two quads. One with a betaflight3, the other omnibus F4 v5. Both quads the external beeper will not activate from the Aux switch allocated to the beeper. settings same on both quads.
# get bee…
-
See https://github.com/betaflight/betaflight/pull/10909 for background.
Using an AIRFLEETG4 V11 FC with NERC-HYBRIDG4 config logging to onboard FLASH works using `blackbox_mode=MOTOR_TEST` however …
-
## Current Behavior
So I decided to move from betaflight to INAV (my drone is an X8 cinelifter), everything seemed to work fine initially , but then under outputs tab in INAV when I tried to move m…
-
Using a 2 axis servo gimbal on a quadcopter on main branch, Ark Fmu-V6x FC with control allocation, dshot output on outputs 1-4 (motors), and PWM 400hz on outputs 5&6 for gimbal servos.
mnt_mode_i…
-
**Describe problem solved by the proposed feature**
Is it possible to get turtle mode functionality (similar to betaflight) in PX4. This functionality is highly desirable in cases where you crash at …
-
I would really like to see the new S2M protocol by FETTEC, which is a good bit faster and more efficient (comparable to dshot1200) and seems to handle telemetry in a very clean way. The protocol _coul…
-
## Current Behavior
The motor does NOT spin.
## Steps to Reproduce
1. Connect the configurator
2. Select Outputs tab
3. Configure Motors IDLE power to 15%
4. Enable 'I understand the risks…