-
Hi Terjeio,
You mention in the readme that the max voltage for the optocoupled DC spindle output is limited by C7 = 30V but there is actually 2 other limiting factor.
- The high side P mosfet t…
-
Using FETs, it is possible to build a "diode" without voltage drop. Explore this option for the next revision.
-
Hi, sorry to open ticket for my question , actually I intend to made modular ESC in way that controller + gate driver is separated from Mosfets pcb , hence I could increase module ampere by adding par…
-
https://docs.arduino.cc/resources/schematics/A000057-schematics.pdf
-
I would love to see other inputs except AM and FM, primarily SSB. One can then try different product detectors, demodulators.
Also another component, a dual gate mosfet, i know its possible to use…
-
BOM appears to be incomplete:
- MOSFET clips for heatsink are not included. Is Type THFU 1 the correct one?
- I guess insulating pads would also be required?
- Fuse for F1 is not included
- jump…
-
I built an EFI circuit using your electronic schematic, only I used a MOSFET driven by a TL555 in the gate buffer mode.
I would like to send you the schematic I used for you to post it along with you…
-
-
### Description
While doing some validation of the mini E3V2 I noticed some nasty oscillation on the hotend mosfet drain pin. At first, I though it was a bit peculiar as I just assumed the hotend…
-
**I merged several of my comments back into the OP**
I've got three assembled PCBs which I built from the `main` branch at JLCPCB. Unfortunately all three are showing the same presumably firmware …