-
Thank you very much for adding the documentation about the pinouts.
It would be nice if you could also add a column in the pinout table of the SODIMM pinout that documents the voltage level of eac…
-
I recently acquired a T-Embed, but when trying to add an RC522 module, I came across this doubt: how do I reference the GPIO pins? Which numbering corresponds to the MISO, CLK, and SDA pins? I searche…
-
Hi! Could you upload a schematic or diagram of the wire connections to directly solder the Ethernet cables as in the image in the repository? I have seen that only 5 cables are being used instead of t…
-
https://pinout.xyz/pinout/gpclk
-
Do you have any information on the 18-pin power going from the power distribution board to the MT70-HD0 mainboard.
Looking at the pictures it looks like it would all be 12V and GND other than the pur…
-
confused which one is clock, which one is SWDIO?!
PA13 (SWDIO) and PA14 (SWCLK) .
-
Hi,
I can't seem to find the pin numbers for the IMU to the Nucleo/Arduino.
-
I think the Hanshow Nebular has different pinouts for the GPIO lines. I notice that the SPI comms are not working for the LUT tests.
So, in main.h I see:
#define EPD_RESET GPIO_PD4
#define EPD_DC …
-
If you compare the small images and the large image the pins on the lower right are wrong.
-
Hello,
please can explain how you calculate BCM pinout mapping? I'm searching for it on the web all the day but found nothing about the link of physical with BCM pins.
(i'm trying to add pin mapping…