-
After following the guide, I foolishly looked at the model number on the Y-Axis Stepper and determined it to be the 1.2a model. I also verified that in the printer.cfg they were set to 1.2.
Howeve…
-
Hello!
My 3D printer configuration: SKR-V2 (BigTreeTech) + TMC2209 (BigTreeTech) working on UART. In Marlin config file TMC2209 drivers set up.
I encountered a problem sometime ago. After the 3D pri…
-
I'm not quite sure the problem, it may be due to current/voltage, or the wiring of the `stepper -> TMC2209`. The wiring should be the same as [this schematic](https://github.com/quintindunn/StringArtR…
-
Hi,
in your config, you use TMC2209_STANDALONE drivers.
In the same file (https…
-
Hi,
I have just installed the ERCF with ERB v1.1 board, flashed the RP2040 with newest klipper:
`mcu ercf(rp2040)
Version: v0.11.0-241-gffb5105b
Load: 0.00, Awake: 0.00, Freq: 12 MHz,`
After …
-
I have an ebb36 connected to a u2c.
All fans and end stops work.
heater and thermistor works.
The only thing I can’t get working is the extruder tmc2209. Using the config from the GitHub with P…
-
I have TMC2209 v1.2 drivers connected to Ramps 1.4.
Everything works fine except ability to trigger end-stops using sensor less homing
Can somebody tell how to connect BTT tmc2209 v1.2 diag pin to r…
-
Hi all, I've been attempting to configure two 2209 stepper drivers sharing a single UART on an STM32G0B1RE based board (using the stm32duino framework) and have come across an issue initialising both …
-
Hello, I'm trying to connect [tmc2209 v3.1](https://aliexpress.ru/item/33027610442.html?sku_id=67201619468) to UART,
jumper in right place, like in manual
 was recognized, but the endstop resource never be used.
My actual configuration …