-
Hi guys I'm trying to use udmabuf on a simple loopback design here is my device tree that I plan to use:
Do I need to define memory region of udmabuf nodes for RX and TX dma channels?
I don…
-
Following the README as well as adding the repo/vivado_library/ folder to my IP sources I am still getting this error when opening the .xdc project file from the release.
> [Designutils 20-1280] Co…
-
ryuzさん，こんにちは．
私は現在ZYBO-Z7-20とRPi-cam(imx219)の接続テストをしていて，
ryuzさんのzybo_z7_imx219プロジェクトをインポート・テストしてみたいと思っています．
ですがインポート方法がわかりません．
方法でも参考となる資料でもなんでも構いません．ご教授頂きたく思っております．
宜しくお願い致します．
デバイス：ZYBO-Z7-20，…
-
I have downloaded and cross compiled the demo on Ubuntu VM. Following transfer to the Zybo it runs under Petalinux but the image is distorted and lined.
If I run fbset I get
![image](https://use…
-
If a bigger/better heat sink can not keep the die temperature low enough in typical air flow conditions (I don't want to rely on forced airflow for these crates, most people don't seem to bother with …
-
Hello,
Don't know if it's really an issue in the configuration. I'm a newbie with Vivado and ZYNQ devices.
Vivado 2018.3 reports four criticial warnings when I validate the design:
> [PSU-1] …
ghost updated
5 years ago
-
I've re-cloned the repo from the scratch.
Whether I used `boot.bin devicetree.dtb uImage uramdisk.image.gz` received by `make fetch-ramdisk` or used those files made by myself using` class ZynqConf…
-
@artvvb
WARNING: [Boardtcl 53-1] No current board_part set.
while executing
"current_board_part"
invoked from within
"set board_part [current_board_part]"
(file "C:/git/Zybo-Z7-20-p…
elodg updated
5 years ago
-
Hello,
There is extra "s" in the link below so its broken this way.
https://github.com/Digilent/Zybo-Z7-10-DMA/releasess
Check this line: "Download the most recent release ZIP archive ("Zybo-Z…
-
When I use Rocketchip1GExtMen and ZynqConfig, I cannot implement it on zybo-z7-20. I got the error that hardware resources are not enough to implement this design. So it only works on zc706?
fpga-zyn…