-
Like described in the instructions for the Arduino IDE you have to "force" the size of the ROM to flash the Heltec Wifikit 32.
Actually you must not change the board name :
```
[env:geiger]
boar…
-
-
### The problem
hi all,
i made a battery-powered air quality sensor, using BME680 with ESP32 (Firebeetle DFR0654). The ESP32 is powered by 2 LiFePO in parallel directly connected to the 3v pin of…
-
### The problem
For no reason Huawei LTE is connected to other intergrations
Even after simple cleanup inside config/.storage/core.*
### What version of Home Assistant Core has the issue?
2024.…
pxFIN updated
10 hours ago
-
I tried this library with my BME680 and I am 100% sure it gives wrong results in warmer rooms. The formula used to calculate `tvoc` is definitely not properly accounting for temperature. In a room wit…
-
I am trying to make but I get multiple failures with folder names changing and folder positions changing from 1.4.6.0. I have tried various combinations but cannot get beyond this error. It is beyond …
-
I cut off pins 2 to 10 so I could fit a bme680 on my Pi Zero. After lots of investigation it turns out VCC for the 2.13 Inch E-Ink Display pHAT is not on pin1 of the 40 pin connector, but on pin 2.
…
-
Hi,
I registered a new device (multigeiger) which originally only had the geiger tube installed. Thus, I removed the second sensor field. Now I added a BME680 to the device but it seems like I can'…
ituri updated
2 years ago
-
Hey I see you are one of the few that seem to be using OPi Z2 to run octoprint. Have you had any luck finding and running any GPio plugins? I want to read a BME680 and control a fan based on it's read…
-
**Describe the problem you have/What new integration you would like**
BME688 sensor integration - with at least RP2040.
**Please describe your use case for this integration and alternatives …