-
Arduino IDE 2.2.1 all libraries updated to current available.
Attempting to run a DS18B20 Dallas Semiconductor temp sensor on the "I2C" JST connector of a LilyGO T-Display S3.
The reading was -127 w…
-
`The DS18X20 B7 chip die (found in the DS18B20, DS1820S, and DS1822 products) can experience EEPROM data corruption failures during power on reset.`
`Since the EEPROM holds internal trim values (in…
-
Hey,
i try to use the dragino lsn50 with a DS18B20 and a ~10m J-Y(ST)Y cable. But it looks like there are timing issues in the software with a higher cable capacity? So with the cable extension the …
-
Hello,
I test Sonoff ZBR3 with your first release firmare with temperature sensor DS18b20.
I use this relay for control electric heater in water tank.
In HA with mqtt i see temperature from sens…
-
### The problem
All was fine, but recently when I upload firmware via OTA or simply build firmware bin file, I got a bunch of compile errors, segmentation faults etc... They seem to be completely r…
-
I will have multiple DS18B20s on different data pins and will need to access them based on that rather than in series on a single One Wire circuit. I've looked at both the CPP and Header files and can…
-
Hi,
I'm very new with esp32 and esp-idf and I try to learn how to use it.
The, at the first try with your code, I've got the following
```
-- Configuring done
-- Generating done
-- Build f…
-
Thanks alexryd, your plugin works beautiful for my and our house – thanks a lot!
I would like to use a shelly uni as temparature sensor. Is it possible to display the two sensor temperature-values …
-
Bonjour,
Pour utiliser les sondes de températures DS18B20, il faut passer les lignes suivantes (tiré du site Adafruit 'https://learn.adafruit.com/adafruits-raspberry-pi-lesson-11-ds18b20-temperature-…
-
At the moment it is only allowed to either use a `config-description-ref` or a `config-description`. It would be very useful to combine both.
Usecase:
The OneWire binding defines a lot of thing-…
J-N-K updated
5 years ago