-
@jacoburge I got my pads, thanks, looks good so far.
I haven't tried my changes yet, I'll get to that shortly, after I play a bit.
But first bug is when you exit the LED pattern mode, all LEDs are…
-
Dear Martin,
today I used the first time led stripes on the MIW. I have the software version 2.07 on it. When it boots and the version appears on the ttgo also the led on the stripe (I have only on…
-
Hello folks!
Thanks for this great library, I'm trying to make it work with a 64x32 coreman matrix RGB led with not success so far.
I've checked the wiring (I'm using power shifters) and the lib…
-
I have used a variation of your sketch for a bluetooth-enabled cloudlamp and it works magnificently. Am now attempting to modify it for a variant that uses a pushbutton to switch between modes in cas…
-
I am kind of attached to the [WLED community](https://github.com/Aircoookie/WLED) and tried to connect your CC app to WLED (i.e. the esp32 running it). Via UDP Sync it "kind of worked", but all LEDs …
-
Actually more comments (not actually issues) again I can't use the QQ chat to contact the author.
Upgrading PWM refresh rate to reduce color smear:
I have done a simple head to head test compari…
-
https://github.com/maemo-leste/hildon-home/blob/0d32a53e8a18b69e9472d56ea26a19cba210a649/src/hd-incoming-events.c#L1387
suggests that hildon-home should activate the corresponding mce led pattern how…
-
Probably 1 can bus, figure out if it supports 24 or 32 LEDs. Likely will need a single relay for a button, etc. Some way to show fault or warning codes.
-
## Have you checked borgbackup docs, FAQ, and open Github issues?
Yes
## Is this a BUG / ISSUE report or a QUESTION?
Issue on documentatioon
Following up borgbase/vorta#1487, I'm raising t…
-
things to check:
- [ ] rx signal received
- [ ] battery voltage within limits
in future:
- [ ] IMU connected
- [ ] TOF connected
- [ ] battery balanced