-
1. What is the sense of commands:
```
RUN curl -fsSL https://raw.githubusercontent.com/platformio/platformio-core/develop/platformio/assets/system/99-platformio-udev.rules | sudo tee /etc/udev/rule…
kolod updated
2 months ago
-
Hi, I've been testing arduino communication with serial.
during running it always connected , buy sometime the read is incorrect
python in run in version 3.9 in Debian 11
I'm using aioserial whi…
-
Can't open esp32s file system...
Device：ESP32S
Mu-editor 1.1.0 beta 6
log：
```
T…
-
## :white_check_mark: Checklist
- [x] I have searched open and closed issues for duplicates.
- [x] This is a problem observed when **deploying** a Data Safe Haven.
- [x] I can reproduce this …
-
Hi, as discussed I made a python serial flasher to read, write and erase flash memory without the need for external hardware other than a USB-to-serial converter.
You can check it out the project h…
-
Type: Bug
When doing CTRL+X via keyboard (and perhaps the menu, but I do not usually use that and it it slower to do), there is a race condition possible when VSC is lagging hard enough.
What happe…
-
## Bug report
**Issue details**
When I'm running sitl with webots-python model I'm getting issue with mavlink connection. It says "MAV>link 1 down"
This is command which I've used to start SIT…
-
Hi,
Using the bootloader I was able to change the baud rate to 57600.
At first I replaced the baud rate of 1000000 by 57600 in the scripts:
- stream_visualizer.py (lines 253-254)
- cdm32…
-
Check which combinations of C++/Python/HOC errors in serial/MPI modes are correctly handled and propagated.
Some improvements have been made recently:
- https://github.com/neuronsimulator/nrn/pull/16…
-
**Describe the bug**
After reading https://github.com/gphoto/libgphoto2/issues/968, I tried to run:
```
gphoto2 --trigger-capture --trigger-capture --trigger-capture
```
However, only one ca…