-
**Inputs:**
- RAW audio file
- Calibration noise level [dB V^2/Hz^2], typically -90 V2 /Hz2
(instrument calibrated with white noise input (-90 V 2 /Hz 2 ) in anechoic and electrically shielded…
-
We do `sensor calibration` and `radiometric calibration` using this repository, but the output is not satisfying.
We did the final statement `not satisfying` because the output photos are not well…
-
@gordian is going to bring the supplies to build some more of the calibration circuits.
-
**Issue Details**
When performing a calibration, the process just goes through without me having to blow into the pitot
After above-mentioned calibration, the speed with no wind reads at ~9m/s or ~3…
-
Sometimes it is necessary to remove the transmitter for cleaning or sensor tuning.
After re-inserting it on the same sensor, it would be nice to restore the saved calibration
data.
-
From @sanderux: https://github.com/mavlink/qgc-user-guide/pull/120#issuecomment-350517356
I have a much better way to calibrate the current sensor. It uses 2 readings, a low and a high current readin…
-
There is also an issue with the sensor pose calibrarion with the checkerboard. the code seems to be good, but the image is not getting loaded again after the waitkey, moreover, there is no such method…
-
Hi, awesome library port.
I came across this library testing out motors and looking more into the MIT actuators by Ben.
I was using simpleFOC with this board and they found that full SPI is ava…
-
Checklist for ESD glider deployment todo tasks. Note that file paths are relative to the top-level glider folder (i.e. glider-YYYYYmmdd)
# Before deployment
## Glider Build
- [x] Determine what batt…
-
### The problem
The response at first is perfect I can call the wake word and is very quick to respond. However if I don't use it for a while, and I have done some testing and it's about 15 minutes…